Photoshop design aluminum ice bucket stock graphics in photoshop.

Today I am telling you about How to Create Photoshop design aluminum ice bucket stock graphics in photoshop.

[1] Take a new file of 400 pixels, 400 pixels, of resolution 72 dpi in the RGB mode.

[2] Now Open New Layer & then create the following shape with the help of ‘Pen Tool’ right click select ‘Make Selection’

[3] In Make Selection ‘feather radius’ should 0 pixels,Tick on New Selection & then ok
& fill the selection with #5a5d70 your image should look like as shown below.

[4] Take the “Dodge Tool” & then Highlight the following parts as shown below.

[5] Take the “Burn Tool” & then create the following Shading
with the help of Burn Tool.

[6] Create a new shape with the help of ‘Elliptical Marquee Tool’ open a new layer fill the selection with #626578.

[7] After that create the following selection with ‘Elliptical Marquee Tool’ then go to
Select>Modify>Feather Selection by 1px.

[8] Now press Cntl+Shift+I. With the “Burn Tool” create the following Shading as shown below do not ‘D’ select.

[9] With the “Dodge Tool” & then Highlight the following parts as shown below do not ‘D’ select.

[10] Now press Cntl+Shift+I, take the “Dodge Tool” & then Highlight the following parts.

[11] Now Open New Layer & then create the following shape with the help of ‘Pen Tool’ right click select ‘Make Selection’
In Make Selection ‘feather radius’ should 0 pixels,Tick on New Selection & then ok & fill the selection with #4b5167.

[12] With the “Dodge Tool” & then Highlight the following parts as shown below.

[13] With the “Burn Tool” create the following Shading as shown below.

[14] Now create a small circle with the help of ‘Elliptical Marquee Tool’ fill that layer with #22211f.

[15] Make the duplicate layer a few times with the help of Cntl+J and place it like me.

[16] Take the ‘Brush Tool’ set your brush size see in the next image.

[17] Now create a new layer make sure your foreground is set to #7f839e. Now create ‘Stroke’ with the help of
‘Pen Tool’ right click select ‘Stroke Path’ now select ‘Brush’ click ok.