tutorialqueen.com

Today I am telling you about How to Create Photoshop design steel ring stock graphics in photoshop.

[1] Take a new file of 500 pixels, 500 pixels, of resolution 72 dpi in the RGB mode.

[2] Now Open New Layer & then create the following shape with the help of ‘Pen Tool’ right click select ‘Make Selection’

[3] In Make Selection ‘feather radius’ should 0 pixels,Tick on New Selection & then ok
& fill the selection with #959595 your image should look like as shown below.

[4] Now create the following selection with the help of ‘Polygonal Lasso Tool’ then go to
Select>Modify>Feather Selection by 1px.

[5] Take the “Burn Tool” & then create the following Shading
with the help of Burn Tool.

[6] Now like this create the following Shading as created in the previous step.

[7] Take the “Dodge Tool” & then Highlight the following parts as shown below.

[8] Make the duplicate layer with the help of Cntl+J, then go to
Filter>Noise>Add Noise apply these settings.

[9] Now go to again Filter>Blur>Motion Blur apply the following settings.

[10] For this layer set Opacity 64%.

[11] Now Open New Layer & then create the following shape with the help of ‘Pen Tool’ right click select ‘Make Selection’
In Make Selection ‘feather radius’ should 0 pixels,Tick on New Selection & then ok & fill the selection with #818382.

[12] And now create the following selection with the help of ‘Pen Tool’ then go to
Select>Modify>Feather Selection by 1px.

[13] Open a new layer fill the selection with Black color.

[14] Now like this create the other with above techniques.

[15] With the “Dodge Tool” & then Highlight the following parts as shown below.

[16] With the “Burn Tool” create the following Shading as shown below.

[17] And now take the ‘Brush Tool’ apply these settings.

[18] Now create a new layer make sure your foreground is set to #7c7c7c. Now create ‘Stroke’ with the help of
‘Ellipse Shape Tool’ right click select ‘Stroke Path’ now select ‘Brush’ click ok.

[19] With the “Dodge Tool” & then Highlight the following parts as shown below.

[20] Now select ‘Brush Tool’ again then press F5 apply the following settings as shown image below.

[21] Now create a new layer make sure your foreground is set to Black. Now create ‘Stroke’ with the help of
‘Pen Tool’ right click select ‘Stroke Path’ now select ‘Brush’ click ok.

[22] Now like this create the other with above techniques.

[23] Hope you will make modifications and make a more better.

http://tutorialqueen.com/photoshop-tutorials/photoshop-cloning-photo-effect